Page 1 of 1

Sinking Angle

PostPosted: Mon Aug 12, 2013 9:29 am
by ghostil
How to set the angle of flooding(Sinking) for a ship?

Re: Sinking Angle

PostPosted: Mon Aug 12, 2013 9:51 am
by Deutschmark
Hi ghostil, welcome to the VSF forums part of this site.
You can not, its been talked about already over at the VSF forum, all ships in VSF sink from the X.Y.Z point set on the hull and that needs to be set in the middle at the bottom of the keel to act right in VSF.

I do hope you are talking about VSF and not IL2.

Deutschmark

Re: Sinking Angle

PostPosted: Mon Aug 12, 2013 11:52 am
by ghostil
Deutschmark wrote:Hi ghostil, welcome to the VSF forums part of this site.
You can not, its been talked about already over at the VSF forum, all ships in VSF sink from the X.Y.Z point set on the hull and that needs to be set in the middle at the bottom of the keel to act right in VSF.

I do hope you are talking about VSF and not IL2.

Deutschmark

In the model, is that all?
Image
This sink ship in VS7 i add only this angle.
I can not this angle in VSF.

Re: Sinking Angle

PostPosted: Mon Aug 12, 2013 12:06 pm
by Deutschmark
That is right VS 7 you can do that BUT in VSF you can not.

Deutschmark

Re: Sinking Angle

PostPosted: Mon Aug 12, 2013 12:07 pm
by ghostil
I want to make here is this angle.
Image

Re: Sinking Angle

PostPosted: Mon Aug 12, 2013 12:18 pm
by Deutschmark
I don't know how you can do that in VS7 or VSF, if there was a damage model then you could do it BUT there is no damage model in them sims.

Deutschmark

Re: Sinking Angle

PostPosted: Mon Aug 12, 2013 4:57 pm
by ghostil
Deutschmark wrote:I don't know how you can do that in VS7 or VSF, if there was a damage model then you could do it BUT there is no damage model in them sims.

Deutschmark

And if in 3d max it stand upright?
When I tried to put it in the mud model Titanic but there are many sites for IL-2.

Re: Sinking Angle

PostPosted: Mon Aug 12, 2013 5:18 pm
by Deutschmark
Am not sure what you are trying to say.

Deutschmark