b-17 start???? - Printable Version

+- All-Aircraft-Simulations (https://allaircraftsimulations.com)
+-- Forum: IL2 MODS Download & Discussion (https://allaircraftsimulations.com/forumdisplay.php?fid=267)
+--- Forum: IL-2 4.09m (https://allaircraftsimulations.com/forumdisplay.php?fid=348)
+---- Forum: IL2 MODS Discussion Section 4.09m (https://allaircraftsimulations.com/forumdisplay.php?fid=292)
+---- Thread: b-17 start???? (/showthread.php?tid=60123)

---

b-17 start???? - wolf_288 - 20.03.2009

Hi
After I installed the UI 1.1 installer and I use 4.08 + mod ,can

---

- jak24610 - 20.03.2009

use the engine selection in teh control menu


select engine #1

select engine#2

select engine#3

select engine#4

Hope this helps

---

- fly_zo - 20.03.2009

.. moved to proper forum section

Z

---

- 911dan - 20.03.2009

ENGINE START

Set the parking brakes.
Use the icon or keystroke to bring up the co-pilot's panel.
Confirm the fuel supply is turned to "ALL".
Set prop governor gauge in upper right corner to T/O (align needle with first red index mark).
Bring up the Electrical Panel and turn on the battery switches.
Bring up the Engine Panel using the icon or keystroke.
Set cowl flaps to the full open position for Engine 3.
Confirm master ignition switch is turned "ON".
Confirm magnetos for Engine 3 are set to "BOTH".
Bring up the Electric Panel using the icon or keystroke.
Turn on the boost pump for Engine 3.
Set the mixture for Engine 3 to "Full Rich."
Check fuel pressure is 15 psi on copilot's panel.
Open the throttle slightly.
Press and hold the engine start switch until the engine starts.
Idle at 1,000 RPM and check for rise in oil pressure.
Turn on the Generator switch for Engine 3.
Repeat this procedure for Engines 4,1, and 2 in that order.
Turn on Avionics Master.

---

- KC Jones - 20.03.2009

jak24610 Wrote:use the engine selection in teh control menu


select engine #1

select engine#2

select engine#3

select engine#4

Hope this helps

You left out the most important one:

"Select All Engines" - after startups.

Else you'll be doing "doughnuts" hock:

---

- KG64_Cnopicilin - 21.03.2009

911dan Wrote:ENGINE START

Set the parking brakes.
Use the icon or keystroke to bring up the co-pilot's panel.
Confirm the fuel supply is turned to "ALL".
Set prop governor gauge in upper right corner to T/O (align needle with first red index mark).
Bring up the Electrical Panel and turn on the battery switches.
Bring up the Engine Panel using the icon or keystroke.
Set cowl flaps to the full open position for Engine 3.
Confirm master ignition switch is turned "ON".
Confirm magnetos for Engine 3 are set to "BOTH".
Bring up the Electric Panel using the icon or keystroke.
Turn on the boost pump for Engine 3.
Set the mixture for Engine 3 to "Full Rich."
Check fuel pressure is 15 psi on copilot's panel.
Open the throttle slightly.
Press and hold the engine start switch until the engine starts.
Idle at 1,000 RPM and check for rise in oil pressure.
Turn on the Generator switch for Engine 3.
Repeat this procedure for Engines 4,1, and 2 in that order.
Turn on Avionics Master.

lol

---