Starting the F86, CA27 engine....
#2

Right Jambo, I too have learnt the joys of Histomod Big Grin

Well for taking of the F86 Sabre I followed LeBigTed's advice of writing it down but I'll tell you how I remember it know :wink:

I get in, and press 8 (Battery ON)
Then I press External Power (6)
Then Master Switch (You'll have to set this key)
Then move the throttle to 3% like in the instructions
Then press starter switch (7)
You should here 2 clicks then the engine should kick in, and leave until the the dial is at full (About 15 seconds)
The cut the started switch and External Power and push the throttle forward and release parking brakes :wink:

Then that should get you off the ground :wink:

Planemad
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)