17.06.2011, 23:44
Hi everyone! Hi fireskull !
Just did that turn back...
I needed a PURE 3.06 on UP3 to run a particular test. So in #SAS file:
- I neutralised --MAPMODS (upped ) and applied an older MAPMODS.
- I neutralised the --STD (upped +.rc upped ) and applied the original STD (saved).
- deactivated UP3 in JSGME and selector chose SAS Modact 3 to run.
...did my test whith SAS 3.06 ( lonesome ); it went like a charm... even the test itself did well...
UPDATE: I have removed one of the step above by installing all my all.ini 's in a maps file within the STD's, the same
as is done in the original #UP# file. This way all the ini files are within STD, and switching MAPMODS, is no longer required.
Nadia Wrote:If you go into WEIRD option 3, there is no turning back,...
Just did that turn back...
I needed a PURE 3.06 on UP3 to run a particular test. So in #SAS file:
- I neutralised --MAPMODS (upped ) and applied an older MAPMODS.
- I neutralised the --STD (upped +.rc upped ) and applied the original STD (saved).
- deactivated UP3 in JSGME and selector chose SAS Modact 3 to run.
...did my test whith SAS 3.06 ( lonesome ); it went like a charm... even the test itself did well...
UPDATE: I have removed one of the step above by installing all my all.ini 's in a maps file within the STD's, the same
as is done in the original #UP# file. This way all the ini files are within STD, and switching MAPMODS, is no longer required.