[Rammjäger]

I'm running into problems when building bridges on a new map.

I know how to place, move, rotate and extend new bridges on a map. However, as soon as I've placed a bridge, hit save and load again, an error message pops up (I forgot the exact text). I can close the pop-up and the map will be loaded in the FMB. When I take a look at the bridge again, there's not one but two bridges on the same spot. After several load/saves there wil be a multitude of bridges on the same spot. I have to repeatedly press delete to get rid of them all. Obviously, this way it is not going to work and to this date I still have no bridges on my map.

Does anyone recognise this problem? Is there a solution??

[caldrail]

You might try checking your hotkey lists. Perhaps you've assigned an instruction incorrectly?

[Rammjäger]

Well I have only assigned the hotkeys to be able to move, rotate and extend the bridge. I'm not sure what could have gone wrong?

[Rammjäger]

Bump. I hope someone recognizes my problem as described above?! I'm still stuck.