07.03.2009, 18:58
Specifically: OutsideMapCell = 28. This sector of the load.ini is used for maps with a lot of sea and a small amount of land.
[MAP2D_BIG]
OutsideMapCell = 28
tile tile.mat
sizeX 600000
sizeY 600000
ofsX 179200
ofsY 222000
I've set the size of the map with sizeX and sizeY; I've offset my map_c, map_h etc with ofsX and ofsY so the island that I want in the middle of the map is dead centre.
However, my Y-axis 10km grid on the map is showing negative numbers, beginning at -2 and going up to 56 (the grids below -2 don't have numbers at all :? .)
I was hoping that OutsideMapCell controls this but it doesn't seem to have an affect whatever it's set to, and is 28 on other sea maps as well.
So, what does it do and how do I get my Y-axis to start at zero?
:cheers:
[MAP2D_BIG]
OutsideMapCell = 28
tile tile.mat
sizeX 600000
sizeY 600000
ofsX 179200
ofsY 222000
I've set the size of the map with sizeX and sizeY; I've offset my map_c, map_h etc with ofsX and ofsY so the island that I want in the middle of the map is dead centre.
However, my Y-axis 10km grid on the map is showing negative numbers, beginning at -2 and going up to 56 (the grids below -2 don't have numbers at all :? .)
I was hoping that OutsideMapCell controls this but it doesn't seem to have an affect whatever it's set to, and is 28 on other sea maps as well.
So, what does it do and how do I get my Y-axis to start at zero?
:cheers: