[PapaG39]

since I installed the 1.1 & patch 1.1 I am having major difficulty in seeing enemy aircraft against the ground.

Prior to 1.1 I used one of those extra Dll's & one of them worked just fine in bringing out aircraft at a normal view range.

Now they just don't show up until I'm shot down.

These new maps are nice, but the aircraft just blend in until they are about .7, but they start shooting about 1.0 so l don't even have a chanch...


Are there any newer Dll's out that will help with this problem .

I really don't want to go back to the pre-1.1 setup, but I may have to so I can see again.
I don't like using labels, but I do know that is an option...

I have the nvidia GeForce 8800 GTS 512 drivers veresion 178.13

Any ideas ?

[wraith]

You could try updating your card drivers- I've read posts saying the 178.24 drivers are the best for Il2, others say the later drivers do better.

You might want to try the 5 dll's released after 4.09b ? I've read posts reporting good results from these dependant on your own setup.

If none of the above work try some of the work-arounds in the tech help section, most involve changing your config.ini and/or Nvidia control panel settings.

A low tech solution is reducing your resolution- give it a go. If you dont like the graphics you can change it back.

[PapaG39]

I just uninstall/downloaded installed the newest Nvidia drivers...The 182.50's which really seem to be very good. I haven't done a lot of different map testing yet, but on the slovakia map they are definately better.

I'll retry those 5 Dll's again. Perhaps one of them will really stand out again...