WIP Panzer III ausf.N
#1

[Image: tankwip.jpg]
[Image: AMPS-PzkwIIIAusfN.jpg]

hey all i snaped a shot of my work so far on the Pz.III. below is a pic of the tank itself. Also i'm slowly doing away with my tester enamel paint's and going with tamiya acrylic's so hoping for better paint job with them.
any advice on weathering would be much needed, note i don't have a air brush yet hehe. thanks for looking!!!
Reply
#2

I just happen to use the same paints as you.
Reply
#3

Good job on what you've done so far.
Tamiya paint and products are the best!(No need to buy thinner anymore, horray!)
Airbrushing, I have not done in years, but I have used a couple of Testors spray cans to make a air rifle camo colors recently. Just hold it not too close and do sweeping strokes. I use weathering chalks like ground up soot and rust and diluted silver to weather some of my stuff without an airbrush.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)