How do I replace the default normandy map in DCG campaigns
#1

Hi

I would like to replace the default normandy map used in dcg campaigns with the new mod maps with the british coast, is there a simple guide on how to do this? I have tried before but failed
Reply
#2

This is a project which is WIP.

I've joined forces with Scharnhorst to create DC's on new maps and will commence my part of the project this sunday.

It's a fairly complicated thing to change, so please do have patience.

Cheers!
ArcticViper
Reply
#3

So currently none of the modded maps are being used for any dcg or dgen campaigns,is this the case? (shame if it is)
Reply
#4

Kennel Wrote:So currently none of the modded maps are being used for any dcg or dgen campaigns,is this the case? (shame if it is)


i'm using it since day one :wink:

To replace default normandy2 ( one with the island) with my bob ..... just place all files from fly_zo_BOB folder to Normandy folder . Then rename any of fly_Z_normX_load.ini files to "load.ini" ( depends which season you like ....) .

If you're using vpmedia's default map pack .... watch it cos it will overwrite your files !

Before going online make sure that you disable normandy folder ( servers runs default map ...)

Z
Reply
#5

Hi

I installed your bob map Fly Zo, and it is located in the mods folder however I cant access it through full mission builder, so I am missing something, any ideas?
Reply
#6

Kennel Wrote:Hi

I installed your bob map Fly Zo, and it is located in the mods folder however I cant access it through full mission builder, so I am missing something, any ideas?


check for double all.ini files ..... if you've installed my map with auto installer your "proper" all.ini should be located here : Mods\mapmods\maps\all.ini . Remove any other all.ini you may have inside Mods folder

Z
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)