13.01.2008, 05:24
Asheshouse,
A variation on your method is to find an area at 0 meters, select "Object/Height/Peek", click on that point with insert selected, I use Ctrl MouseLeft=insert+ in my config. This is effectively a paste function of that height. Now go to where you want your height to be 0 meters, select "Object/Height/Fill" and use your insert function again. Voila! You have 0m!
I have not figured out an undo function, there may not be one except raise the height manually again if you get alter the wrong spot. I always keep plenty of backups of previous work in case it goes drastically wrong.
CW
A variation on your method is to find an area at 0 meters, select "Object/Height/Peek", click on that point with insert selected, I use Ctrl MouseLeft=insert+ in my config. This is effectively a paste function of that height. Now go to where you want your height to be 0 meters, select "Object/Height/Fill" and use your insert function again. Voila! You have 0m!
I have not figured out an undo function, there may not be one except raise the height manually again if you get alter the wrong spot. I always keep plenty of backups of previous work in case it goes drastically wrong.
CW