[Miri's Hot]

Hello Gentlekiller, to answer your question on making the SLI mode work. First you would need another nvidia 7600gs and set it up thru your opperating system. But if your building a new system you might consider a graphical upgrade to more powerful cards. As to "faking" the game out to get the wide screen 1920 X 1200 It's right here from the config. ini walk-through:

Screen resolutions and how to fake it out.

window] this describes how windows displays the game on screen
width=1024 resolution width in pixels set in display properties settings tab in windows
height=768 resolution height in pixels set in display properties settings tab in windows

LCD native resolution was not included as an option if it is bigger than 1600 X 1200

Here's How:

Enter your screen values here and change the SaveAspect=1 to 0

Save and start your game.... (if you later open the IL-2 Setup and close it by clicking OK it will change the resolution to 640x480 16bit, unless you change it to something else via this IL-2 Setup.)

Now here's the important bit............, when you start up the game it will look rather hazy and low quality. If you go into video settings/modes in the game options it will say 800x640 or some other low resolution level, DO NOT CHANGE THESE APPARENTLY LOW QUALITY SETTINGS, when you start the game it WILL be in your glorious high res native resolution. If you then set the conf file to "Read Only" in it's properties after you exit the game, you can stop it changing back every time you go into Set Up.

Words from "Chebawookie"

Hope that helped

Miri's Hot