10.05.2008, 13:38
Taurus,
The TGA that you need for the base of the pedal arm is pipehorizontal5.tga the screws for this are on transgadgets.tga (both of these were taken from the P63).
The landing gear lever looks really good now that you gave it the treatment.
As for the fuel switches, it appears to me that they are part of a big block of mesh contained in Left.msh and cannot be moved individually. That skewed area beneath the flap lever is also in Left.msh. :evil:
This is going to be a tough nut to crack.
Theoretically it would be possible to cut out the "fubar" parts and find some replacement for them. We could even fashion a fuel switch mesh that could be moved independently by taking a copy of Left.msh and cutting out everything except the fuel switch parts.
For parts that are supposed to be animated this would be more difficult of course, but I don't think that the fuel valves are animated.
I looked at the area that the flap lever is attached to more closely. It appears to be meshed as a flat area, that you were able to give it the appearance of depth with your texturing is pretty impressive. However, I was wondering if it would look less skewed if you were to make those two boxes "appear" to be half as raised as they "appear" now.
I will work on the fuel valve mesh a bit and let you know what I come up with.
Good Luck
Poncho
The TGA that you need for the base of the pedal arm is pipehorizontal5.tga the screws for this are on transgadgets.tga (both of these were taken from the P63).
The landing gear lever looks really good now that you gave it the treatment.
As for the fuel switches, it appears to me that they are part of a big block of mesh contained in Left.msh and cannot be moved individually. That skewed area beneath the flap lever is also in Left.msh. :evil:
This is going to be a tough nut to crack.
Theoretically it would be possible to cut out the "fubar" parts and find some replacement for them. We could even fashion a fuel switch mesh that could be moved independently by taking a copy of Left.msh and cutting out everything except the fuel switch parts.
For parts that are supposed to be animated this would be more difficult of course, but I don't think that the fuel valves are animated.
I looked at the area that the flap lever is attached to more closely. It appears to be meshed as a flat area, that you were able to give it the appearance of depth with your texturing is pretty impressive. However, I was wondering if it would look less skewed if you were to make those two boxes "appear" to be half as raised as they "appear" now.
I will work on the fuel valve mesh a bit and let you know what I come up with.
Good Luck
Poncho