11.05.2008, 20:10
I was able to reposition the fuel valve switches with the above procedure. The new positioning below is probably not correct, and needs perspective work as well. I will check the archives for reference.
Taurus, I'm sure you have noted the poor quality of the switchbox. If you could give that a good texture treatment to make it pop. I will try to isolate the mesh on that also. Looking at photos it appears to be A) too far recessed and B) facing slightly down instead of slightly up.
Other observations:
-The seat is too narrow in proportion to the cockpit.
-The round fuel selector should be near the front left corner of the seat, the square selector should be by the switchbox. With this arrangement there should not be much space between the two fuel selectors. With the seat the way it is there is too much space. In photos the cable attached to the left of the rudder pedal runs between the two fuel selectors.
Sorry for going on, too much coffee.
Poncho
Taurus, I'm sure you have noted the poor quality of the switchbox. If you could give that a good texture treatment to make it pop. I will try to isolate the mesh on that also. Looking at photos it appears to be A) too far recessed and B) facing slightly down instead of slightly up.
Other observations:
-The seat is too narrow in proportion to the cockpit.
-The round fuel selector should be near the front left corner of the seat, the square selector should be by the switchbox. With this arrangement there should not be much space between the two fuel selectors. With the seat the way it is there is too much space. In photos the cable attached to the left of the rudder pedal runs between the two fuel selectors.
Sorry for going on, too much coffee.
Poncho