12.05.2008, 04:33
So much good work poncho, well done, I did not think it was possible.
I will make a post and edit it as there is much to be done. If there is a major change I will make a fresh post.
Changes will be outlined below the reference pic.
The fuel switch should be mounted on the switchboard! The other switch should be inboard of the rudder pedal channel. Just how you have got them. Reference is vital so holler if it is sparse.
. Foot pedal texture colour wrong during render. I have the right texture now and will reapply it. You gave me the right texture but I had the shading all wrong which is what threw me. It had to be much darker.
. Floor texture colour wrong during render. I have the right texture now and will reapply it along with main structural changes.
. That little yellow panel on the switch board is just to show that this IS the side panel textures also. I will be doing a full model and render of this to make it pop.
. The recognition panel on the right will get a full model and render.
. The main leather joystick cover will get a full 3d model and render to blend it in.
. I am preping the seat to start modelling belt buckles.
. The brone-back head rest cushion and plate will get some attention too. (No where near comparison to what Flushi could do!
)
Still lots of work to do!
[EDIT] Just to clarify things. When I mean 3d model it is purely for texture creation only. Just incase anybody reading this missed some of the previous posts.
I will make a post and edit it as there is much to be done. If there is a major change I will make a fresh post.
Changes will be outlined below the reference pic.
The fuel switch should be mounted on the switchboard! The other switch should be inboard of the rudder pedal channel. Just how you have got them. Reference is vital so holler if it is sparse.
. Foot pedal texture colour wrong during render. I have the right texture now and will reapply it. You gave me the right texture but I had the shading all wrong which is what threw me. It had to be much darker.
. Floor texture colour wrong during render. I have the right texture now and will reapply it along with main structural changes.
. That little yellow panel on the switch board is just to show that this IS the side panel textures also. I will be doing a full model and render of this to make it pop.
. The recognition panel on the right will get a full model and render.
. The main leather joystick cover will get a full 3d model and render to blend it in.
. I am preping the seat to start modelling belt buckles.
. The brone-back head rest cushion and plate will get some attention too. (No where near comparison to what Flushi could do!
)Still lots of work to do!
[EDIT] Just to clarify things. When I mean 3d model it is purely for texture creation only. Just incase anybody reading this missed some of the previous posts.