[fabianfred]

sure it IS hard work...but fun too :wink:

in the load.ini ...the textures applied to each in the [Fields] section

LowLand0 = land/summer/LowLand_2neu.tga
LowLand1 = land/Pacific/field5_burma.tga
LowLand2 = land/Pacific/fields_kevtungatt2.tga
LowLand3 = land/Pacific/field_Clay.tga

MidLand0 = land/summer/LowLand_2neu.tga
MidLand1 = land/Pacific/fields_kevtungatt2.tga
MidLand2 = land/Pacific/field5_burma.tga
MidLand3 = land/Pacific/fields_kevtungatt2.tga

Mount1 = forest/summer/JungleFarBurma.tga
Mount0 = forest/summer/JungleKTABurma.tga
Mount2 = forest/summer/JungleFarBurma.tga,2
Mount3 = forest/summer/JungleKTABurma.tga
Country0 = forest/summer/JungleFarBurma.tga,2
Country1 = forest/summer/JungleFarBurma.tga,2
Country2 = land/Pacific/JungleKT.tga
Country3 =land/summer/sk_fields_mount2.tga

City0 = land/summer/fsk_country_mount.tga
City1 = land/summer/bigcountry.tga
City2 = land/summer/burmavillage.tga
City3 = land/summer/sk_fields_mount2.tga

AirField0= land/summer/fields_airfieldBurma.tga
AirField1= land/Pacific/Imphal_af_new.tga,-2
AirField2=
AirField3=land/Pacific/PalauField01.tga

Wood0 = forest/summer/JungleFarBurma.tga
Wood1 =
Wood2 =
Wood3 =

Water0 = land/summer/LowLand_2neu.tga
Water1 = land/Pacific/field5_burma.tga
Water2 = land/summer/grnd/fields_sand3.tga ;water/CoralCoastLine.tga, -2
Water3 = land/Pacific/fields_kevtungatt2.tga ;land/summer/grnd/fields_sand3.tga

lowland0 being the lowest in height .....and progressing up to country3 .... and sometimes even using city or airfield textures with maps of great height differences

see in Airfield2 there is no texture assigned...then if I use that texture in the FMB to lay a Tile...it will use the previous one = Airfield1

this is from my new Burma map and you will notice that I have applied textures to even the Water0 - 3 because there is some very low lying land which is at or below sea level....and otherwise it uses the WATER tile which is black as you can see in this uncorrected shot....