[MOD] Focke Wulf FW-190 A-3 ver 1.6 *01.08.09*

TSmoke Wrote:OK have read this entire thread and have not found a solution to my problem.

Did a fresh install of 1946....patched it to 4.08......tested and it ran.....installed the unified mod pack....tested and it ran......installed new aircraft installer 2.8.....tested game it ran.....installed FW190A3.....tested game it ran. However the A3 doesn't show up as a usuable aircraft....it shows up in the MOD folder, has a 3DO folder, presets, samples, and 5 other files.

It shows up in the PaintSchemes folder, but the folder is empty?? Is this why it will not show in Quick Combat ??

Have always been cautious with mods and only install One at a time test run game then move on. Any ideas or help would be appreciated. Thanks.


only thing i can think of would be not choosing 1 in prompt menu while installing mod .... question to allow rearranging air.ini alphabetically .

So please check if you have this line present in air.ini ( \MODS\STD\com\maddox\il2\objects\air.ini)

Fw-190A-3 air.FW_190A3 2 g01 SUMMER

also make sure you have this in plane_ru.properties (\MODS\STD\i18n\plane_ru.properties):

Fw-190A-3 FW-190 A-3, 1942

and at the end these lines in weapons_ru.properties (\MODS\STD\i18n\weapons_ru.properties) :

#####################################################################
# Fw-190A-3
#####################################################################
Fw-190A-3.default Default
Fw-190A-3.u1 U1: 2xMG 151/20 Only
Fw-190A-3.u11sc250 U1: 2xMG 151/20 + 1xSC 250
Fw-190A-3.u11ab250 U1: 2xMG 151/20 + 1xAB 250
Fw-190A-3.u3 U3: 2xMG 17 + 2xMG 151/20 Only
Fw-190A-3.u31sc250 U3: 1xSC 250
Fw-190A-3.u31ab250 U3: 1xAB 250
Fw-190A-3.u31sc500 U3: 1xSC 500
Fw-190A-3.u31ab500 U3: 1xAB 500
Fw-190A-3.u31tank U3: 1xType D Droptank
Fw-190A-3.u82tank U8: 2xType D Droptank
Fw-190A-3.u81sc2502tank U8: 1xSC 250 + 2xDroptank
Fw-190A-3.u81sc5002tank U8: 1xSC 500 + 2xDroptank
Fw-190A-3.r1tank300 R1: 1xType D Droptank
Fw-190A-3.r1sc500 R1: 1xSC 500
Fw-190A-3.r6wfrgr21 R6: 2xWfr.Gr. 21
Fw-190A-3.none Empty

* .ini files can be edited via notepad

hope this will help

Z
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 6 Guest(s)