[|ZUTI|]

Hey lowfighter. Just one question: how does this behave when you try to populate a map using this template? I mean, when i was doing mine for cities (i didn't do it for factories :\) i had a problem with overlapping buildings. In some cases there were up to three buildings in one spot after i populated the map. That's why i wrote a java application that filtered those out for me but i just couldn't make a template that would avoid this. The template itself was clean but at some point the pattern starts to repeat and that was the main problem, i think. So, you had problems like that? Or haven't tested it yet?

Well, if you'll let me, i'll try to use it on my map and see what it does on the boarders with cities. But then again, i can trim the factory regions by hand later on, since i don't have that many factory place on the map Good luck.