[FA_Bong]

This sounds like a calibration issue or a worn out stick, go to the Saitek profile icon on your task bar, control panel, and look at the box that shows your stick axis, is it centered? when you move it and let it go does it go to center? does it seem to wobble or jump around, when you move it in very small adjustments does it jump around? If it does your stick maybe wearing out, go to the tab marked deadzones and look at the X-Y axis the red bar should be dead center if it isnt, try putting a dead zone just large enough to cover where the red line is set, this might cover enough to eliminate the wander, but if you have a wear and tear issue it might only help for a short while. I just replaced my old X-45 for just that very reason you described.