24.07.2009, 09:19
I've not tried the Korea map yet so not able to comment on the map specifically.
The problem you describe is either due to
1. the airfield area not having the blankplates present
2. or because the ground is not level at the airfield.
To check 2. use FMB to check the ground levels (H) . They should be the same over the whole airfield area, or at least on the runway areas.
for 1., maybe they are not using the UI 1.1 standard plates. If so there should be a note in the installation readme.
The problem you describe is either due to
1. the airfield area not having the blankplates present
2. or because the ground is not level at the airfield.
To check 2. use FMB to check the ground levels (H) . They should be the same over the whole airfield area, or at least on the runway areas.
for 1., maybe they are not using the UI 1.1 standard plates. If so there should be a note in the installation readme.