21.08.2009, 11:49
I looked for an answer on this all over the Forums and could not find it, so I figure I will ask it here.
I have the IL2 1946 install, updated from 4.7 to 4.8, then installed UI1.1 and its patch. Works great. I then put in IL2 Stab as I wanted to use the resolutions settings there among the other useful goodies I found in it too
Anyhow, if I use the switcher, to use the other version how can I go about using IL2 Stab so I can retain my screen res? It currently launches the sim at ver 4.09 and shows the different splash screen, so I figure it is running the UI version, which is great.
Probably answer my own question now, had an idea, if I was to edit the config file to set my resolution in the alternate file folder, than would it retain that for only that version? Otherwise "Help".
Cheers, Jeff
I have the IL2 1946 install, updated from 4.7 to 4.8, then installed UI1.1 and its patch. Works great. I then put in IL2 Stab as I wanted to use the resolutions settings there among the other useful goodies I found in it too
Anyhow, if I use the switcher, to use the other version how can I go about using IL2 Stab so I can retain my screen res? It currently launches the sim at ver 4.09 and shows the different splash screen, so I figure it is running the UI version, which is great. Probably answer my own question now, had an idea, if I was to edit the config file to set my resolution in the alternate file folder, than would it retain that for only that version? Otherwise "Help".
Cheers, Jeff