[Fireskull]

Greetings, all. I'm attempting to install IL2 from the cd onto a new gateway computer running windows 7. I've read several posts about turning off the user account control (done that) and trying to run the program from either a new folder on the desktop or from a different partion on your hard drive....

However, when I insert the cd into the computer it 'spins' for a bit, and then stops. No prompt to install the program, nothing....

When I open the cd to see the files, I can click on 'setup' and it will once again 'spin' for a few seconds and then stop.

I miss flying! If I wanted this level of frustration I would have stayed married to my first wife. Any help for this newbie???

Hello, Mr. Jones, and welcome to All Aircraft Simulations.


1) User Account Control stays ON in my computer - IL-2 installed and runs just fine, including the installation and running of all mods. Turning the User Accont Control OFF will make your computer much more vulnerable to malware and hackers.


2) I have IL-2 as a major folder in the same disk as my operating system. The shorter file path causes IL-2 to load and run slightly better. Did you know that a disk is considered a folder by your operating system? I have IL-2 as a major folder alongside Windows, Users, Program Files, Program Data, and so forth.

You can also run IL-2 as a major folder in another disk just fine, including an external disk drive.


3) Some DVD sets of IL-2 require both disks for installation. If you insert only one or insert the 2nd disk only/first, then you might have an issue. Try a DVD of another title to test your drive.


This topic was moved to PC Technical Help Forum.



IL-2 Newbie Guide
viewtopic.php?f=29&t=29314


IL-2 Guide for Computers, Benchmarking, Optimizing, Tweaking
viewtopic.php?f=30&t=22314




Fireskull