Adding Planes mods,& maps to HSFX 5.0
#5

Thanks Fireskull for a better explanation...I found I needed to "install" all the new folders in a separate folder & then "paste" them into the game main folder manually.This may be just a fault of my install in that the usual point installation to my game folder didn't seem to work ( I know it should have - I have no explanation..) Having said all that this is an amazing patch improvement.In initial run thru I notice nice improvements in map textures & sounds...terrific default effects as well...so much so that i recommend you go slowly with importing "old" effects,because a.) you might not need them & b.) they may cause conflicts. As a PM response so aptly commented "Its been out only one day & you are already adding mods to it?"
I did need to add widescreen4.10 for sure & will add a few planes for campaigns I started elsewhere- this will be the place for my default game play.So much good here its hard to know where to start!
On the small problem side ( & this just might be me) egine start exhaust when viewed from insude the plane ( esp in one of the lovely perfect 109's) is very horsey looking...very much like smoke in original Il-2 from way back.I'll take a screenshot if anyone wants to see this effect.
In any case- big thumbs up!
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 4 Guest(s)