[macky123456789]

Hi all,

I have a clean IL-2 1946 installation with some AAA mods installed. Everything ran smooth and fine so far.

Now I just discovered one problem: I started a career "Fighter (South)" with JG77 beginning with the Kuban42 map. Mid of September this Kuban part of the career is over and the Stalingrad campaign should begin. But instead of a new mission I got a blank screen, without map and mission orders. I then tried to start another campaign with another pilot beginning with Stalingrad to check if this error happens again. And indeed, when I pressed the green start button to begin the new career, all I heared was a "beeeeep" tone. Nothing happend. Starting the career with the same pilot and the same settings AFTER or BEFORE Stalingrad is no problem.

Do you have any suggestions, hints or explanations?

[macky123456789]

No one here with a helping hand or suggestion???

[hello]

Sounds to me it is a DGen problem, nothing to do with mods. You might try to contact the usual DGen specialists. Best bet probably at SimHQ.

[macky123456789]

@hello: thx for the reply. But changing/updating DGen didnt work.

Any other suggestions how to solve this little problem?

[Murph]

Have you tried posting your question in the "missions" section of the site?

[macky123456789]

... not yet. but I will. Thx for the hint!