[typhoon27]

I seem to have picked up a very frustrating problem with the back button since going to the latest SAS buttons. The whole mess, and it is a mess, flies very well as do the new planes. However, whenever I try to change the load out or a skin, the first return works, but on the next screen, when I press the "back" button the whole thing fails on the background. This results in the Crt/Alt/Del being used and starting over. The strange thing is that the change was recorded and is there, when I go back to the campaign to carry on. I have have tried to search for a missing command line, but have not yet found it. I may be looking in the wrong places, but have not found the error. I did try to get some assistance from the SAS board, but because I am still on the "beta"install there was no direction given. I do not, at this time, have the luxury of going to the new 409 or doing a complete re-install. Any suggestions as to how I might correct this or where to look for the problem would be a great help.
Thank you for any assistance you might be able to offer.
With respect,
Typhoon 27

[shardana]

usually when i had a major problem after installing something i just went to windows recovery and pick a one, two days recovery point. it has worked for me.

[typhoon27]

Thank you for your suggestion. I did try that and returning to the previous button, which did not present the problem, but neither worked. I still suspect that something has gone amiss in a command line within the IL2 folder, but have yet to locate where it might be. To fine tune the problem a bit more, it only occurs when in the campaign selected. The back button in the "set difficulty" section works as does the one in the listing of all the campaigns. This makes me think it may be a command or instruction line that has been damaged.
Thank you again,
With respect,
Typhoon27