Sinking Angle
#1

How to set the angle of flooding(Sinking) for a ship?
Reply
#2

Hi ghostil, welcome to the VSF forums part of this site.
You can not, its been talked about already over at the VSF forum, all ships in VSF sink from the X.Y.Z point set on the hull and that needs to be set in the middle at the bottom of the keel to act right in VSF.

I do hope you are talking about VSF and not IL2.

Deutschmark
Reply
#3

Deutschmark Wrote:Hi ghostil, welcome to the VSF forums part of this site.
You can not, its been talked about already over at the VSF forum, all ships in VSF sink from the X.Y.Z point set on the hull and that needs to be set in the middle at the bottom of the keel to act right in VSF.

I do hope you are talking about VSF and not IL2.

Deutschmark
In the model, is that all?
[Image: e-2XmjrMxho.jpg]
This sink ship in VS7 i add only this angle.
I can not this angle in VSF.
Reply
#4

That is right VS 7 you can do that BUT in VSF you can not.

Deutschmark
Reply
#5

I want to make here is this angle.
[Image: VdM5fbzplxQ.jpg]
Reply
#6

I don't know how you can do that in VS7 or VSF, if there was a damage model then you could do it BUT there is no damage model in them sims.

Deutschmark
Reply
#7

Deutschmark Wrote:I don't know how you can do that in VS7 or VSF, if there was a damage model then you could do it BUT there is no damage model in them sims.

Deutschmark
And if in 3d max it stand upright?
When I tried to put it in the mud model Titanic but there are many sites for IL-2.
Reply
#8

Am not sure what you are trying to say.

Deutschmark
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)