15.06.2009, 14:58
If that's the start, we can only imagine where it will end up. 
My First Attempt at Painting an IL2 Skin
15.06.2009, 15:47
Very nice work!
Awesome job!
Awesome job!
15.06.2009, 16:00
As said mate, all you need to do is lower the panel line opicity and its spot on 
16.06.2009, 06:20
Good Morning All,
I had some free time last night so I tweaked the RAF 209 PBN skin so more. As per the much-appreciated advice given, I toned down the panel lines and retinted the exhaust streaking on the top of the wings. I also dulled out the finish as well as it seemed a bit too glossy, and I continued the camo stripe up along the wing support pylon. Here is where I am at so far. Let me know if I am heading in the right direction, and thanks again folks.
![[Image: RAF_209_PBN_B_01.jpg]](http://raf209squadron.net/louvert/RAF_209_PBN_B_01.jpg)
Cheers!
Lou
I had some free time last night so I tweaked the RAF 209 PBN skin so more. As per the much-appreciated advice given, I toned down the panel lines and retinted the exhaust streaking on the top of the wings. I also dulled out the finish as well as it seemed a bit too glossy, and I continued the camo stripe up along the wing support pylon. Here is where I am at so far. Let me know if I am heading in the right direction, and thanks again folks.
Cheers!
Lou
16.06.2009, 06:25
Nearly there mate.
If you are using a 'speckled' layer you might want to either lower the opicity or add some gacian blur to the layer mate, looking now it looks a bit to heavy (to my eye anyway)
If you are using a 'speckled' layer you might want to either lower the opicity or add some gacian blur to the layer mate, looking now it looks a bit to heavy (to my eye anyway)
« Next Oldest | Next Newest »
Users browsing this thread: 1 Guest(s)