[Tom]

Dear all,

all of a sudden my shift+F1 has stopped working regardless of what plane I'm in. I have 6DOF disabled and I have gone through the various aircraft making sure that any cockpit mods are turned off, but no joy!

Any suggestions?

Edit: Shift+F1 in a FW puts the "bar" in place, but that slides around depending on the angle of my TrackIR. I have disabled the bar mod too but no change.

[Guest]

Ok this may be a real dumb question but ,have you gone into the control section to see if anything of your commands have changed?

[Tom]

Ok this may be a real dumb question but ,have you gone into the control section to see if anything of your commands have changed?

I have, but even with different keys mapped the problem remains.

I have also made sure that 6DOF is wholely removed and that it is not enabled in my TrackIR settings.

[Burning Beard]

This may seem like a silly question, but have you checked your keyboard? Mine has a dual function "F" key mode on it. You may have punched this by accident.

Beard

[Tom]

This may seem like a silly question, but have you checked your keyboard? Mine has a dual function "F" key mode on it. You may have punched this by accident.

Beard

Single function keyboard - no function lock and I've used other keys. It's almost as if the reticules are locked like when the RAF reticules mod is used.

[USAFE]

I have the same problem, Shift F1 no longer functions, Standard key board and even tried to change the settings in controls to use another key, all to no avail.

[USAFE]

I have the same problem, Shift F1 no longer functions, Standard key board and even tried to change the settings in controls to use another key, all to no avail.

:arrow: If you install the new Installer update, it resolves the issue with Shift F1. Many thanks, a lot of work has gone into this, congratulations.

[USAFE]

You are correct, and installed, works great, and congratulations, you have done an outstanding job and thank you.