22.03.2009, 21:16
Hello folks,
I've been working on a new a/c model for some weeks now - I'm using MAX 9 (32-bit). Last night after working on my project, I saved the scene as usual. However, a little later, I went back to open the file, I got the message : file failed to open. Despite repeated attempts, I have the same problem. I scanned the file for viruses (nothing appears to have infected it), tried copying the file and opening that, but still the same problem. It's very annoying because a lot of work has gone into this, and I don't have an original backup of the scene. Have any other MAX users had this problem before? Is there a way to fix this? Hoping somebody has an answer to this, or I face having to start the whole project again from scratch
Thanks in advance
Hawkers
I've been working on a new a/c model for some weeks now - I'm using MAX 9 (32-bit). Last night after working on my project, I saved the scene as usual. However, a little later, I went back to open the file, I got the message : file failed to open. Despite repeated attempts, I have the same problem. I scanned the file for viruses (nothing appears to have infected it), tried copying the file and opening that, but still the same problem. It's very annoying because a lot of work has gone into this, and I don't have an original backup of the scene. Have any other MAX users had this problem before? Is there a way to fix this? Hoping somebody has an answer to this, or I face having to start the whole project again from scratch
Thanks in advance
Hawkers